6
SAFETY INSTRUCTIONS….cont
Always wear eye protection when using or maintaining any air tool.
We recommend wearing ear protection - particularly during extend-
ed periods of operation.
We recommend wearing a face mask or respiratory equipment when
using any air tool; particularly during sanding, grinding, sawing or other
operations likely to cause airborne particles.
CAUTION:
The warnings and cautions mentioned in this user manual can not
cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which can-
not be built into this product, but must be applied.
3/8” Reversible Air Drill
Instruction Manual
Quick Coupler (Euro type)
Small Bottle of Oil
Chuck Key
CONTENTS & ACCESSORIES
Note:
If any of the above are missing or damaged, contact your distributor
immediately.
Understand the operating environment; Before each use the operator should assess,
understand and where possible reduce the specific risks and dangers associated
with the operating environment. Bystanders should also be made aware of any risks
associated with the operating environment.
11
MAINTENANCE
Disconnect the air tool from the air supply before changing accessories, servicing
or performing maintenance. Replace or repair damaged parts. Use genuine parts
only. Non-authorised parts may be dangerous and will invalidate the warranty.
DO NOT
use the tool if it is, or has parts that are worn, damaged or missing; re-
move from service and have the parts repaired / replaced using original spare
parts.
Ensure that the air tool is lubricated daily with a few drops of air tool oil dripped into
the air inlet.
Clean the air tool after each use.
Check hose and fittings for wear or damage before each use.
Drain the air tank / receiver of the compressor daily; Water in the air line will dam-
age the drill.
In the event that it becomes necessary to store the tool for an extended period of
time (overnight, weekend, etc.), it should receive a generous amount of lubrication
at that time. The tool should be run for approximately 30 seconds to ensure oil has
been evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
Note:
Never start the drill with the bit touching the work-piece. Allow the drill
to reach full speed before starting the drilling (or similar) operation.
OPERATING INSTRUCTIONS….cont
TROUBLESHOOTING
The following form lists the common operating issues with problems and solutions.
Please read the form carefully and follow it.
If any of the following symptoms occurs during your operation, stop using the
tool immediately, or serious personal injury could result. Only a qualified person
or an authorised service centre should perform repairs of the tool. Disconnect
from the air supply before attempting repairs or adjustments. When replacing O
-rings etc. lubricate with air tool oil before assembly.
