8
SIP Part No.
06724
Chisel Length
190mm
Blows Per Minute
3500
Average Air Consumption
2.3 cfm (65 l/min)
Operating Pressure
6.3 bar (90 psi)
Air Inlet
1/4” bsp
Sound Pressure (LpA) *
84.2 dB(A)
Sound Power (LwA) *
95.2 dB(A)
Vibration **
14.0 m/s
2
Guarantee:
This SIP air hammer is covered by a 12 month parts and labour warranty covering fail-
ure due to manufacturers defects. This does not cover failure due to misuse or operat-
ing the air hammer outside the scope of this manual - any claims deemed to be out-
side the scope of the warranty may be subject to charges Including, but not limited to
parts, labour and carriage costs.
The warranty does not cover consumable parts such as chisels.
Failure to lubricate your air tool will shorten its working life and reduce performance.
The warranty does not cover rusting air tools and tools that failed due to the lack of
lubrication.
Note:
Proof of purchase will be required before any warranty can be hon-
oured.
TECHNICAL SPECIFICATIONS
GUARANTEE
* Measured in accordance with ISO 15744:2008.
** Measured in accordance with EN 28662-1, EN 28662-5 and EN ISO 8662-9; level of uncertainty 7.4%
.
9
1.
Ensure the air drill trigger (3) is not depressed before connecting to the air sup-
ply.
2.
You will require an air pressure of 90psi, and an air flow according to specifica-
tion.
3.
WARNING!
Ensure the air supply is clean and does not exceed 90psi while oper-
ating the air hammer. Too high an air pressure and unclean air will shorten the
product life due to excessive wear, and may be dangerous causing damage
and/or personal injury.
4.
Drain the air tank daily; water in the air line will damage the air hammer.
5.
Recommended hook-up procedure is shown in fig 1.
6.
Line pressure should be increased to compensate for unusually long air hoses
(over 8 metres). The minimum hose diameter should be 3/8” I.D. and fittings
must have the highest flow rate that can be fitted to the tool.
7.
Keep hose away from heat, oil and sharp edges. Check hose for wear, and
make certain that all connections are air tight secure.
This 190 mm air hammer is designed with a durable lightweight housing. It has a built
in air regulator for precise start-up and control, forward facing exhaust to reduce noise
and direct air flow away from the operators face. It is the ergonomic choice.
Tool
Compressor
Quick Connector
Quick Connector
Quick Coupler
Quick Coupler
Air Hose
Regulator
Lubricator
Filter
Cut Off Valve
Fig. 1
DESCRIPTION
AIR SUPPLY
OPERATING INSTRUCTIONS
