Sinteck RPU Link, Руководство пользователя и техническое руководство

Страница: 38 / 40

3-19 Quick guide for installation and use - Strider Receiver Link
Strider Link Series
SRFStrider-161004A-REV.A
Sinteck Sistemas Eletrônicos Ltda.
STRIDER RECEIVER LINK - QUICK START GUIDE FOR INSTALLATION AND USE
This chapter contains the necessary instructions for the installation and use of the
equipment Strider Receiver Link. In case some aspects are not totally clear, for instance
when a user is using this equipment for the first time, we advise the new user to read
carefully the entire description contained in this manual.
PREPARATION
Unpack the Strider Receiver and check, before making any operation, that the unit has not
suffered from any mishandling during the transport. In particular check that all the
connectors are in perfect conditions.
Check that the supply voltage coincides with the AC voltage available.
The input supply field is of:
STRIDER RECEIVER LINK:
110V or 220V switchable
Check that the switch located in the rear panel of the equipment is in position equivalent to
the available voltage.
Check that the switch located in the front panel of the Strider Receiver Link is in the position
“OFF”
The Strider Receiver Link has this switch which interrupts completely the AC supply of the
unit.
Connect the antenna into the RF input connector.
Connect the AC cable to the corresponding VDE socket.
REMARK: It is essential that the AC network has an accurate grounding system in order to
ensure both the safety of the users and the correct functioning of the unit.
USE
Switch on the receiver by putting the selector on the position “ON” the switch situated on the
front panel.
The following message must be viewed:
3
SINTECK
UHF RECEIVER
SINTECK
UHF RECEIVER
Note that this moment the first LED is turned on, indicating the Strider Receiver link has
all supplies voltages “OK
”
03/P/38