Sinotec CRB-3368, Инструкция по эксплуатации

Страница: 8 / 9

During standby mode, press and hold DIMMER for 2 seconds repeatedly to
select high or low brightness levels.
USB Charging
Use the USB charging port to charge your smart phone or to power USB
powered devices such as a USB type lamp or fan.
To Connect your cell phone for charging :
Use a USB cable (not included) to connect your cell phone to the USB
connector of the unit. Your cell phone should start charging.
Remark:
Charging function may not be supported for all phones or electronic devices.
BATTERY BACK-UP
(For Temporary Time Storage Only)
Install (2X AA/ LR6/ UM-3) battery (not included) according to polarity shown inside the
battery compartment. In the event of a power interruption, your set will not work normally
from the mains supply but there is now the advantage that your clock will continue to work.
The clock display will not light up, as the clock time will be held in the memory. This also
enables you to move the set from place to place without re-setting the clock every time. The
battery back-up system is only meant to be used for short temporary power interruption. For
longer periods the battery may become exhausted or there may be some deviation in accuracy.
When the battery is exhausted, it should be removed from the set to prevent leakage. If you
do not wish to take advantage of the battery back-up system, your set will work normally
without a battery. However, if disconnected from the mains, the clock figures will flash when
the mains are re-connected, you must re-set the clock as described in the Electronic Clock
Operation paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don
’t throw used
batteries in dustbin. Please contact your retailer in order to protect the environment.
Attention should be drawn to the environmental aspects of battery disposal.
Electrical products should not be disposed of with household waste. Please recycle at the
appropriate facility. Check with your Local Authority of retailer for recycling the device.
(Battery packs or batteries installed) shall not be exposed to excessive heat such as sunshine,
fire or the like.
SPECIFICATION