Sinoboom 1530SE, Руководство по эксплуатации

Страница: 48 / 90

© Jun 2020 7-2 GTJZ0408SE&0608SE&0408ME&0608ME Operation Manual
OPERATING THE MACHINE
When there's an emergency, machine malfunction or
power loss need emergency pull/drag, release brake
has the following two methods:
Method 1:
1. Wedge the tires to prevent the machine from rolling.
2. Ensure the area is free of obstructions.
3. Make sure the battery power OFF switch is in the
“OFF” position.
4. Remove two end cover bolts and brake cover.
Figure 7-1
Table 7-1
No.
Description
1 Brake cover
2 Brake end cover bolts
3 bolt hole
5. Insert the end cover bolt into the two separate holes
on the brake housing.
6. Tighten the end cap bolts downward and the brakes
on the drive motor will detach.
7. The above steps are repeated in the drive of the
other wheel. after the two drive motors have sepa-
rated. the machine can be moved by human power.
8. After traction, pad the wheel and remove the end
cover bolt from the separation hole.
Method 2:
1. Turn the key switch of the ground controller to the
ground control position.
2. Push the emergency stop button on the platform
controller to the ON position.
3. Push the emergency stop button on the ground con-
troller to the ON position while holding down the en-
ter button for five seconds, and the program setting
interface appears on the display screen.
4. Press page down key until the display appears "Ma-
chine Mode", then press the enter button.
5. Press page down key until the display appears
"Break Release", then press the enter button.
6. At this time, the horn sounded, while the buzzer
sounded all the time, the brake was released
successfully.
7. the machine can be moved by human power.
OPERATING ON THE
GROUND
Before operating the machine:
1. Switch the key switch on the ground controller to
the ground control position.
2. Pull the emergency stop button on the ground con-
troller out to the ON position.
3. Ensure the battery is connected to the machine be-
fore operating the machine.
To adjust the platform position:
1. Operate the lifting/lowering switch on the ground
controller to control the lifting and lowering functions
of the platform.
2. The ground controller will be unable to control the
machine’s driving and steering functions.
OPERATING ON THE
PLATFORM
Before operating the machine:
1. Switch the key switch on the ground controller to
the platform control position.
2. Pull the emergency stop button on the ground con-
troller and platform controller out to the ON position.
3. Ensure the battery is connected to the machine be-
fore operating the machine.
To adjust the platform position:
1. Press the lifting/lowering button of the platform con-
trol box, which will illuminate the button.
2. Press and hold the enabling key.
3. Operate the handle according to the lift symbol on
the control panel.
To activate the steering function:
1. Press the driving and steering button, which will illu-
minate the button.