sinmag LBC LMO Max-E, Инструкция по установке и обслуживанию

Страница: 11 / 42

© Copyright 2017-2022 LBC Bakery Equipment, Inc. 11 Rev 6/2022
INSTALLATION
(Part 1 of 4) .
General Information
This appliance, when installed, must be electrically grounded in accordance with state and local codes,
or in the absence of local codes, with the National Electrical Code (ANSI/NFPA 70) or the Canadian
Electrical Code (CSA C22.2 No. 3, latest edition) as applicable.
The appliance requires some assembly by an authorized LBC trained service technician.
Do not enclose the top of the appliance to other construction. The top of the oven must be accessible
for service and must not be enclosed or covered. This clearance may be gained by removing baffles,
filters and other components, provided that removing the components does not create a hazard. Gas
Ovens: The top of the oven must also be open and have adequate air supply for combustion.
WARNING
THIS APPLIANCE MUST BE INSTALLED WITH A MINIMUM OF 1 INCH CLEARANCE FROM
SIDES AND BACK AND 18 INCHES CLEARANCE FROM THE TOP TO COMBUSTIBLE
SURFACES.
WARNING
THIS APPLIANCE MUST BE INSTALLED ON A NON-COMBUSTIBLE FLOOR EXTENDING
12 INCHES BEYOND THE APPLIANCE, WITH NON-COMBUSTIBLE CONSTRUCTION
UNDER THE FLOOR.
General Information – Gas Ovens
This appliance must be installed under a ventilation hood.
This appliance must be connected to a gas shutoff valve in accordance with CSA 9.1-M97 – ANSI Z21.15-
1997 and Addenda CGA 9.1 a-2001 – Z21.15a-2001, Manually Operated Gas Valves for Appliance,
Appliance Connector Valves and End Valves.
The installation of this appliance must conform with local codes, or in the absence of local codes, with
the National Fuel Gas Code (ANSI Z223.1/NFPA 54) or the Natural Gas and Propane Installation Code
(CSA B149.1) as applicable, including:
•
The appliance and its individual shutoff valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressures in excess of 1/2 psi.
• The appliance must be isolated from the gas supply piping system by closing its individual shutoff
valve during any pressure testing of the gas supply piping system at test pressures equal to or less
than 1/2 psi.
This appliance is configured to operate on natural gas or propane gas. A gas conversion kit is available
for this appliance. See the name plate on the appliance to determine if the appliance is
configured for natural gas or propane gas. For conversion instructions, see the “Natural/Propane Gas
Conversion” section of this manual.