Singmai Electronics SM06, Руководство пользователя, Страница: 8 / 26

SingMai Electronics
SM06 User Manual Revision 0.4 Page 8 of 26
Figure 4 UTP connector pin assignments.
Should the input to the SM06 be removed or fail, the SM06 will switch to an internal colour bar
generator. The output video standard will be whatever was last detected on the inputs (e.g. if the
last detected input was 1080p/30Hz, the output will be 75% colour bars at 1080p/30Hz standard). If
no valid input has previously been detected, the colour bar output will default to 720p/60Hz.
Note
that the colour bar generator will not operate if the input standard is 720p/59.94Hz,
1080p/29.97Hz or 1080i/59.94Hz.
The SM06 will be shipped set for your requested cable choice (i.e. coaxial or UTP) and is indicated
in the serial number label on the bottom of the module (COAX or UTP). For the automatic cable
compensation and data transfer to operate correctly it is necessary to select the cable input to
extract the data from. To do this, remove the end panel with the HD-SDI input and RS232
connector from the SM06 by removing the four screws in the corners of the panel and pulling off
the panel and black bezel. The top panel can then be slid off (see Figure 5).
Figure 5 SM06 Data slicing selection - J9.