SINED CALDO-IRA-INOX-2000, Руководство пользователя, Страница: 10 / 12

P3: 100% of rated power

TIMER FUNCTION.

The heater is equipped with a programmable timer that automatically puts the heater into Standby
mode after 1, 2, 3, 4 ... max. 13 hours of operation.
To activate the timer, point the remote control directly at the receiver and press the "1 hr" button. 01"
will be shown on the display area as shown below. this will cause the heater to automatically go into
Standby mode after 1 hour of operation. Once in Standby mode, the "- -" symbol will flash.
To set the 13-hour timer, point the remote directly at the receiver and then press 1 2 4 6 on the remote,
"13" will be indicated on the display area. This will automatically put the heater into Standby mode after
13 hours of operation. Once in Standby mode, the "- -" symbol will flash.
ATTENTION:
1, During the running time of the timer, the number on the display shows the remaining time. Example
Fox, the 13-hour timer is activated, the display shows "11" after 2 hours of operation;
2, During the running time of the timer, the display will show the working power and the remaining
timer alternately;

Deactivate or reprogram the timer.
If the timer is activated, pressing the same key a second time will reprogram or disable the timer.
Example 1. After activating the 13-hour timer by pressing pusher "1" "2" "4" "6", then pressing pusher
"1" the timer will be reprogrammed to (13-1) = 12 hours, then pressing pusher "2" the timer will be
reprogrammed to (13-2) = 11 hours. By pressing several other buttons in sequence, the timer can be
reset to 0, the heater enters Standby mode and the "- -" symbol flashes.
Example 2, a 6-hour timer is set by pressing key "2" "4". Press push-button "2", the timer is set to 6-2 =
4 hours, press push-button "4" immediately after, the timer is set to 0, the heater goes into standby
mode and the symbol "- -" flashes.