3
7) Where there is no corrosive gas, heavy dust, salt mist, smog or moisture.
(2) How to select the installation location for the outdoor unit
1) The outdoor unit must be installed where the bearing surface is stable and
secure enough.
2) The outdoor unit and indoor unit should be placed as close as possible to
minimize the length and bends of the refrigerant pipe.
3) Do not install the outdoor unit under the window or between the buildings to
prevent the normal running noise entering the room.
4) Where the flow of the air inlet/outlet is not blocked.
5) The outdoor unit should be installed where ventilation is in good condition so
that the unit can take in and discharge enough air.
6) Do not install the unit where there are inflammable and explosive substances
and where there is heavy dust, salt fog and other severely polluted air.
No air guiding pipe is allowed to be installed at the air inlet/outlet of the outdoor unit.
Under the heating mode, the condensate water would drip down from the base frame
and would be frozen when the outdoor ambient temperature is lower than 0
℃
(32
℉
).
Besides, the installation of the outdoor unit should not affect the heat radiation of the
unit.
CAUTION!
The unit installed in the following places is likely to run abnormally. If unavoidable,
please contact the professional personnel at the Sinclair
appointed service center.
Where is full of oil.
Alkaline soil off the sea.
Where there is sulfur gas (like sulfur hot spring).
Where there are devices with high frequency (like wireless devices, electric
welding devices, or medical equipments).
Special circumstances.
(3) Electric Wiring
1) The installation must be done in accordance with the national wiring
regulations.
2) Only the power cord with the rated voltage and exclusive circuit for the air
conditioning can be used.
3) Do not pull the power cord by force.
4) The electric installation should be carried out by the professional personnel as
instructed by the local laws, regulations and also this manual.
5) The diameter of the power cord should be large enough and once it is
