Sinbo SSI 6611, Инструкция по эксплуатации

Страница: 4 / 12

- 3 -
Dry / Steam
You can fix the steam intensity directly by turning the steam function
“0”= steam dry =maximum steam outflow
Burst of steam
To reach a burst of steam, press the button “short burst of steam” (2).
Attention: Only, use the steam push button when the steam iron has
reached the steam or maximum temperature.
Do not press this button more than 3 times at once.
Keeping/Cleaning/Care
Switch the steam iron off (Put control-position to minimum temperature; see mark on
water tank) and unplug. Put the steam iron upright and let it completely cool down, empty
the water tank.
Remove residues from steam sole with a vinegar-water solution. Rub the cabinet with
a moisted cloth and finally rub it dry.
Automatic electricity interruption for security
In case the installed thermostat gets out of order the power supply will stop automatically
to avoid the steam iron to overheat. In this case the steam iron has to be repaired by the
service point.
ANTI-CLAC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale
build-up in the plate
The resin filter is permanent and does not need replacing.
Please note:
Use tap water only.Distilled and/demineralised water makes the “Zero-Clac” anti-clac
system ineffective by altering its physicochemical characteristics.
Do not use chemical additives,scented substances or decalcifiers.Failure to comply with
the above-mentioned regulations to the loss guarantee.
Self-Clean
The function of self-clean is to clean the soleplate when you use this iron about half of
year.
You must be:
1. Fill the iron and plug in;
2. When the temperature attaches “MAX”, press the self-clean-Button for about 1 minute;
3. Plug into power in order to dry the water in soleplate off
4. Conduct self-cleaning only with a basin to collect all water. Otherwise the hot water
will be spilled maybe over the user.