SImx LHT1058 Скачать руководство пользователя страница 2

We strongly recommend this light fitting is installed by a registered electrician

Switch off the power supply before commencing any electrical work.
Unscrew the fixing cover screws and remove the rear cover.
Use the rear cover to mark the position of screw holes onto mounting surface.
Drill the wall to depth of about 4 cm and fit the wall plugs (supplied).
Care should be taken to avoid drilling or screwing into concealed electrical wiring/plumbing.
Push the cable through the cable gland. Affix the back of the housing to the mounting surface with

mounting wall screws.
Connect the power cables to the terminal block securely (refer to Fig. 1). Refit the terminal block and

cable anchorage. Select lamp colour from internal dip switch (refer to Fig. 2).
Align the power supply pins. Reattach and screw securely the cover to the base.
Ensure cables are not pinched in closing the unit. Reconnect mains power.
Test circuit (see below).
Before any aiming adjustments, switch Eco Spot Select off and allow the hot lamp housings to cool.

The Eco Spot Select should be wired to its own light switch. Do not interconnect with other lamp 

types on the same switch. An earth connection must be used for electrical safety.
To achieve best results, please consider the following points:
Eco Spot Select should be mounted 1.8 to 3.0 metres above the ground.
This light fitting is rated to IP54 making it suitable for sheltered exterior locations, please ensure the 

desired location does not exceed this rating.

BEFORE YOU START

INSTALLATION

Please read all the instructions prior to installation. 

Fig. 1

Fig. 2

Selecting lamp colour with power supply connected 

may cause irrepairable damage. Always disconnect 

at mains before making any colour seletion.

This product is guaranteed by Ventair Pty Ltd for 3 years from the date of purchase against faulty materials or

workmanship which affects its designed ability to operate. During this period if the product has a

defect of this nature it will be repaired or replaced free of charge by Ventair with the same item, or a similar

one of higher specification. ON CONDITION THAT:
The buyer returns it to the seller from whom it was bought, freight paid.
The product has been bought by the user. ie a receipt/sales invoice is produced as proof of purchase.
The product has not been misused or handled carelessly, installed in anyway contrary to the installation

instructions, used on a supply voltage other than that indicated in the product specifications, or installed

in any unusually exposed or harsh environmental conditions.
This guarantee excludes liability for discolouration of paint or plastic, or any user serviceable parts.  

 

 

It does not confer any rights other than those expressly set out above and does not cover any claims for

consequential loss or damage.
Our Goods come with guarantees that cannot be excluded under the Australian Consumer Law. 
You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably

foreseeable loss or damage. You are also entitled to have the Goods repaired or replaced if the Goods fail

to be of acceptable quality and the failure does not amount to a major failure.

MANUFACTURERS EXTENDED WARRANTY

PRODUCT COMPLIANCES

Product complies with:

 

AS/NZS 60598.1:2017     AS/NZS 60598.2.1:2014     AS CISPR15:2017

EN61000.3.2:2014     EN61000.3.3:2013     EN55015.2013     EN62031.2015     EN62473.2015     

AS/NZS 61347.1:2016     AS/NZS 61058.1:2008     and relevant amendments

N

L

L  = Brown or Red

N = Blue or Black

Отзывы: