We strongly recommend this light fitting is installed by a registered electrician
Switch off the power supply before commencing any electrical work.
Unscrew the fixing cover screws and remove the rear cover.
Use the rear cover to mark the position of screw holes onto mounting surface.
Drill the wall to depth of about 4 cm and fit the wall plugs (supplied).
Care should be taken to avoid drilling or screwing into concealed electrical wiring/plumbing.
Push the cable through the cable gland. Affix the back of the housing to the mounting surface with
mounting wall screws.
Connect the power cables to the terminal block securely (refer to Fig. 1). Refit the terminal block and
cable anchorage. Select lamp colour from internal dip switch (refer to Fig. 2).
Reattach and screw securely the cover to the base. Ensure cables are not pinched in closing the unit.
Reconnect mains power.
Test circuit and setup PIR settings (see below).
The Eco Spot Select should be wired to its own light switch. Do not interconnect with other lights on
the same switch. An earth connection must be used for electrical safety.
To achieve best results, please consider the following points:
Eco Spot Select should be mounted 1.8 to 2.5 metres above the ground.
To avoid false triggering, the sensor should be directed away from heat sources such as barbecues, air
con, flue vents etc.
Do not aim towards reflective surfaces such as smooth white walls, swimming pools, etc.
Before selecting a place to install your Eco Spot Select, note that movement across the scan area
is more effective than movement directly toward or away from the sensor.
BEFORE YOU START
INSTALLATION
Please read all the instructions prior to installation.
Fig. 1
