SImx CHM0155 Скачать руководство пользователя страница 2

Receiver Unit

Transmitter Unit

What is Auto-learning Code?

The Transmitter sends a wireless signal to the Receiver. The Receiver would automatically register and 
memorize the signal as an operation code. So the Transmitter can work with the Receiver by this code.

Auto-learning Code Set Up

1. Operation for 1 Transmitter and 1 Receiver
•  Firstly install the batteries to the Transmitter and Receiver.
•  Now press and hold the top button on rear of the Receiver until the front LED is lit, 

 

 

 

indicating the device is ready to pair.

•  Immediately press the transmitter button once. Pairing will be confirmed by playing of 

 

 

 

selected melody.

NOTE:  Interference from another similar door chime operating nearby

 

(For example, Receiver sounds for no reason):

•  Remove batteries for approx. 2 minutes will wipe the pairing memory. Repeat steps above to re-pair.
•  It is important to remember that when you replace the run-out battery with new one that you may  

 

 

need to follow the same procedure of the auto-learning code set-up as above.

•  Product cannot be paired with multiple Receivers or Transmitters.

Insert 3 x AA Alkaline batteries into the compartment at rear of the Receiver.

INSTALLING THE BATTERY

SETUP THE AUTO-LEARNING CODE

Before fixing the products, check your desired locations can communicate first. The product is rated to 
operating up to a range of 80 metres in free air. The operating range will be reduced if the signal
is transmitted through a number of walls or ceilings.

NOTE: Common barriers to avoid completely include mounting to any metal surface or UPVC door frames. 
Avoid positioning above heat sources such as radiators, or in damp areas such as a kitchen or bathroom. 
Do not expose either unit directly to rain or immerse in water. Do not locate either unit close to fireplace 
or expose to high temperatures.

Note the Receiver is suitable for Indoor use only. The Transmitter is rated for sheltered exterior locations.

SELECTING YOUR MOUNTING LOCATIONS

•  To open the housing, firstly remove the name plate cover. Using a flat head screwdriver,   
 

insert this into the slot on the base of the unit. The rear should pop open. Lever the cover off.

•  Insert the supplied 23A12V battery into the holder at the bottom of the Transmitter, 

 

 

ensuring polarity of battery on installation. Reassemble the Transmitter, ensuring the rear had  

 

clicked into place.

2

Отзывы: