Simrad LOWRANCE TotalScan, Руководство по установке, Страница: 10 / 20

9.
Run the transducer cable up through the grommet on the
mounting bracket (F)
10.
Reattach the transducer bracket to the transom mounting plate
(G)
11.
Set the transducer to the desired angle and tighten the bracket
assembly bolt (with washers) and nylon lock nut
12.
Snap the cable cover into place (H). If needed, you can remove
the cable cover by inserting a flat head screw driver along the
curved edge and pry the clip loose on both sides, one side at a
time.
13.
Route the cable to the display and connect it to the sonar port.
After the transducer is connected and your boat is in the water, turn
on the Flip Left/Right feature on your display to ensure what is
shown on the left and right side on your display corresponds with
what is on the left and right side of your boat. Refer to your display's
Operation manual for more information.
A
C
E
G
F
H
D
B
Direct Step mount (Flush bracket)
Flush mount bracket assembly
To mount the transducer directly to the step (Direct Step mount),
use the flush mount bracket (sold separately, part no.
000-12602-001).
10
Installation | TotalScan Transducer User Manual