Simrad GB40, Руководство пользователя

Страница: 121 / 156

◦
A dotted line extending from your vessel to the edge of
your
Radar screen. This is EBL 1 and the bearing is relative
to your vessel. The default angle is 045° Relative.
◦
A message box showing the range and bearing of the
VRM/EBL. If you can't see this, select
VRM/EBL 1 Data
to turn it On.
•
Select
Floating EBL 1
and a message asks you to select the
EBL center. The Center EBL 1 setting should be Off. (If it's On,
the EBL will be centered on your vessel.)
•
Select the EBL center for the first location, then select
Return
.
¾
To find the range and bearing between two other
locations:
•
Select
VRM/EBL 2
then repeat the sequence. These dotted
lines are shown in a different color.
¾
To show the range readout:
•
You can either:
◦
drag VRM 1 across the PPI until it touches the target OR
◦
select
Adjust VRM 1
then use
Up
or
Down
to increase
or decrease the radius of VRM1 until it touches the target.
The GB40 updates the range readout with each change in
radius.
•
Select
OK
when you're at the target.
¾
To show the bearing readout:
•
You can either:
◦
drag EBL 1 across the PPI until it touches the target OR
◦
select
Adjust EBL 1
then use
Up
or
Down
to move
EBL1 until it touches the target.
The GB40 updates the bearing readout with each change.
•
Select
OK
when you're at the target.
¾
To clear the data:
•
Select
Center EBL 1
then
Return
.
Note: If you select the junction of the EBL/VRM, you can drag
them both at the same time.
120 | Radar