Simpson Amik 300, Руководство по эксплуатации, Страница: 18 / 72

Touching on SYSTEM PARAMETER will open the system parameters list screen. Then these
screens from particular parameter may be scrolled through one at a time in incremental order by
touching the “ key” and in decremental order by touching “ key” on given touch screen.
3.2.1 System Parameters Selection
After entering in the “SYSTEM PARAMETERS”, List of following parameters will be display :-
3.2.1.1 SYSTEM TYPE
3.2.1.2 PT PRIMARY(L-L)
3.2.1.3 PT SECONDARY(L-L)
3.2.1.4 CT PRIMARY
3.2.1.5 CT SECONDARY
3.2.1.6 DEMAND INTEGRATION TIME
3.2.1.7 AUTO SCROLL
3.2.1.8 LOW CURRENT NOISE CUTOFF
3.2.3 RESET PARAMETERS
3.2.4 OUTPUT OPTIONS
3.2.5
BRIGHTNESS & CONTRAST
3.2.1.1 System Type
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
VL2
0.000
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
VL2
0.000
LINE-NEUTRAL VOLTAGE
VL2
VL2
VL2
VL2
0.000
SYSTEM TYPE
3-PHASE 4 WIRE
FOR 3 PHASE STAR CONNECTED LOAD
3-PHASE 3 WIRE
FOR 3 PHASE DELTA CONNECTED LOAD
MAIN MAIN MAIN MAIN MAIN MAIN OK BACK
This screen is used to set the system type.
Two types: 3 phase 3 wire & 3 phase 4 wire system are displayed
on screen. Touching radio buttom in front of particular type will select
that type.
Touch on “ key” will confirm the system type.
Touching the “ key” will keep the old selected setting and will
return to previous menu.
OK
BACK
16
Note : If system type is changed, relay parameter selection & analog output
selection will be set to NONE.
3.2.1.9 ENERGY ON RS485
3.2.1.10 ENERGY DIGIT RESET COUNT