© 2018 Simpson Str
ong-T
ie Company Inc.
-9-
INSTALLATION AND REPLACEMENT OF
THE DRIVER BIT
DRILL/DRIVER ATTACHMENT
The Quik Stik tool is compatible with the drill motor of your choice as long as it
is capable of a minimum of 1,200 rpm, which is very common. It is permissible
to use an impact driver, although tool reliability may be compromised when
used with an impact driver due to additional wear on the tool caused by the
concussive action of the driver motor.
To attach the drill/screwdriver motor to the tool, insert the hex drive shaft of the
Quik Stik tool into the drill/screwdriver motor’s chuck and tighten until snug.
To verify that the Quik Stik tool is
properly installed, cycle the tool
through an installation motion, sliding
the handle and grip over the extension
arm, while the drill/screwdriver motor is
running. The action should be smooth
and when the spring-loaded guide
tube is released, it should return to its
original position.
Quik Stik bit insertion — draw the head back to expose the bit or bit holder;
insert T-30 bit into bit holder.
Quik Stik drill attachment.
A T-30 driver bit is included with the tool and in packages of Strong-Drive
®
SDWC Truss screws (sold separately). To insert the bit, simply push down on
the head of the Quik Stik
™
tool to expose the magnetic bit holder. Slide the bit
into the holder, press firmly until it clicks, and release the tool head back to its
original position. To remove, push down on the Quik Stik tool head, and pull the
bit out of the holder using pliers.
