9
SimpliFire • SF-PP23-E, SF-PP26-E • 2040-901 Rev. D • 10/13
CAUTION! The unit’s power cord must be connected to
a properly grounded and protected 120V outlet. Always
use ground fault protection where required by the electri-
cal code.
CAUTION! Do not operate the unit if it is damaged or has
malfunctioned. If you suspect the unit is damaged, call
a qualifi ed service technician to inspect and replace any
part of the electrical system if necessary.
Note:
To use both remote and manual function, the main
power switch must in “ON” position.
Note:
A harmless slight brief odor may occur during fi rst
use or after prolonged period of storage.
A. Manual Switch Function
The appliance can be operated by both remote control
and manual button. Once the unit has been properly
connected to a grounded electrical outlet, turn on the
main power switch located on the face of the appliance.
See Figure 5.1.
Main Power Switch
The POWER switch supplies power to all function of the
fi replace. This switch must be in the “ON” position for
any of the functions including the remote.
Flame Button
By pressing the FLAME button, the unit will cycle
through four fl ame effects.
Heater Button
- Press the heater button once to turn 750W power on.
Appliance will beep and illuminate 1 red LED.
- Press again turns 1500W power on.
Appliance will beep and illuminate 2 red LEDs.
- Press third time turns heater off.
NOTE:
There is a brief delay between the heater command and
the heating turning ON. When the appliance receives
a heater ON command, the appliance blower will turn
ON for 8 seconds before the heater turns ON. There is
also an 8 second delay between heater off and blower
shutdown.
Main Power Switch
Flame Button
Heater Button
Figure 5.1 Manual Operating Switches
5
5
OPERATING INSTRUCTIONS
