Mower Deck Leveling
Perform these adjustments on a flat level surface.
SIDE-TO-SIDE LEVELING
1. With the mower installed, place the rider on a
smooth, level surface such as a concrete floor. Turn
the front wheels so they are straight.
2. Check for bent blades and replace if necessary.
3. Place the mower cutting height pin in the 4th hole
from the bottom (see insert, Figure 20). Arrange the
outside mower blades so that they are pointing from
side-to-side (Figure 18).
4. Measure the distance between the outside tips of
each blade and the ground (Figures 18 & 19). If there
is more than 1/8” (3mm) difference between the mea-
surements on each side, proceed to step 5. If the dif-
ference is 1/8” (3mm) or less, proceed to step 6.
5. Use the rear leveling links (B, Figure 20) to adjust the
side-to-side leveling of the deck. Repeat step 4 if
necessary.
FRONT-TO-BACK LEVELING
6. Arrange the blades so they face front-to-back (Figure
21).
7. Measure the distance from the ground to the front tip
of the center blade, and from the ground to rear tips
of left-hand and right-hand blades (Figures 19 & 21).
The front tip of the center blade should be 1/4" (6mm)
higher than rear tips of left-hand and right-hand
blades. If not, proceed with steps 8 - 11.
8. Check the length of the hanging rods. The rear (D,
Figure 20) should be 15” (38,1cm) and is not adjust-
ed. To adjust the pitch of the mower deck, adjust the
front leveling nuts only.
9. Loosen the front lock nuts (E, Figure 20).
10. Turn the leveling nuts (A, Figure 20) counter-
clockwise to lower the front of mower deck. Turn the
nuts clockwise to raise the front of the mower. Make
adjustments in small increments, trying to keep ten-
sion on both leveling nuts.
11. Tighten the front lock nuts (E).
12. Re-check the blade measurement then repeat steps
7-11 as necessary.
FastCut Hydro Drive ZTR
TP 300-7237-IR-HZ-N
7/2005
14
Figure 21. Orient Blades Front-to-Back
Figure 18. Orient Blades Side-to-Side
Figure 19. Measure Blade Tips to Ground
A. Mower Deck
C. Level Ground
B. Blade Tip
A
B
C
Figure 20. Mower Leveling
A. Front Leveling Nuts
B. Rear Leveling Rods
C. 4th Cutting Height Hole
D. Rear Hanger Rods
E. Front Lock Nuts
B
D
C
A
E
