Not for
Reproduction
7
GENERAL OPERATING INSTRUCTIONS
General Operating Instructions
Before Operation
Clear the lawn of all sticks, stones, wire and other
debris which may be caught or thrown by the mower
blades.
Check grass condition. If wet, wait until later in the
day. If grass is wet, the grass catcher is likely to
become plugged.
For efficient bagging, air circulation under the
mower deck, through the chute and into the bag is
very important.
For this reason, BEFORE YOU BEGIN MOWING you
should make certain the underside of the mower and
the underside of the catcher lid are free from grass
and debris.
Make sure that there is a snug fit between mower
deck, blower housing, tubes, and grass catcher cover.
Mowing with Double / Triple Catcher
Always operate with throttle at full speed when
mowing.
Always wear hearing protection when operating
grass catcher.
Grass should be cut often, and not too short. If grass
is too long or lush it may be necessary to keep ground
speed to a minimum or to cut only half the width of the
mower to prevent clogging. If grass is long, operate
with mower in high cutting position for first pass,
cutting again in a lower position on a second pass.
Do not open the cover with mower engaged.
If a large amount of cut grass is spilling out from
under deck, the tube may be plugged or the bags may
be full. Discontinue mowing, stop the rider, disengage
the PTO and then empty the catcher or clear the tube.
After Operation
Remove any debris from the screen on the underside
of the lid. Note: The lid screen can be partially
removed for easier cleaning and should be cleaned
regularly.
The blower housing and tube should be removed for
cleaning.
Inspect the grass bags for wear or damage. Make
sure that there is a snug fit between mower deck,
blower housing, tubes, and grass catcher cover.
Storing the Grass Catcher
Clean the grass catcher thoroughly using a mild
detergent (other products may damage the tube).
Remove any debris from the screen on the underside
of the lid. The screen can be partially removed for
easier cleaning.
If paint has been scratched on metal parts, touch
up with paint, or apply a thin film of oil to prevent
corrosion.
Store in a dry area. Hang the catcher and catcher
bags to dry thoroughly before storing for a long period
of time. Always store away from moisture.
Mowing Without the Blower
For operation without the blower, the deflector must
be properly installed in the down position.
To remove the blower, see BLOWER & COLLECTOR
REMOVAL
WARNING
ALWAYS shut off the tractor, disengage the
PTO and allow all moving parts to stop BEFORE
disconnecting or clearing tube, or emptying
catcher.
Before leaving the operator’s position for any
reason, engage the parking brake, disengage
the PTO, stop the engine and remove the key.
To reduce fire hazard, keep the engine, rider
and mower free of grass, leaves and excess
grease. Do not stop or park rider over dry
leaves, grass or combustible materials.
CAUTION
This machine produces sound levels
in excess of 85 dBA at the operator’s
ear and can cause hearing loss though
extended periods of exposure.
Wear hearing protection when operating this
machine.
