10” HEAVY
DUTY PLOW
NOTE: REPOSITION BEAM END TO THESE HOLES, WHEN
USING PLOW WITH 2-WHEEL TRACTORS.
t h e p l o w i s u s e d
r i t h
t h e
the Beam End to the center
of
the
P l o w B e a m A s s e m b l y a f t e r m o v i n g t h e
to outside of Beam
o
p
p
o
s
i
t
e
o
f
S
p
a
c
e
r
MODEL 725 RIDING TRACTOR
LANDLORD RIDING TRACTOR
ASSEMBLY AND ADJUSTMENT
REQUIRES
HITCH ADAPTER )
1. Remove varnish from moldboard and share, using
a good grade of varnish remover. (Keep greased when
not in use.
CAUTION: Be sure that the rolling, coulter is out of
the ground when the tractor is in reverse gear.
2. Bolt standard ( 1 t o p l o w b o t t o m 2 .
3. Bolt beam 3 t o s t a n d a r d a t 4 . Lock with
nut so that beam
free to swing on standard.
4. Attach depth regulating yoke rod assembly
Pin and cotter pin.
Attach the lift pin and chain assembly ( 9 ) to the
beam at by means of the
and spring clip pro-
vided. The hitch
a d a p t e r 10 is
e d t o t h e t r a c t o r h i t c h b y m e a n s o f t h e p i v o t p i n .
t h e p l o w t o t h e h i t c h a d a p t e r w i t h t h e h i t c h
and insert the lift pin 9 ) In the tractor rear lift
assembly and secure in place
a pin and
c l i p .
5 . A t t a c h r o l l i n g c o u l t e r a s s e m b l y a n d a d j u s t
coulter standard 7 )
that blade runs approximately
7. Wheel weights should be used when operating the
to the left of landslide. Set the rolling coulter
10” Plow. The weights are designed so that as many
for best depth depending upon the soil.
weights as necessary may be added to the wheels
in
M A N U F A C T U R I N G C O M P A N Y ,
