Auger and Impeller Group
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
37
End of hub to be flush
with end of rolled down
shaft (Ref. 9).
Torque to 30 -34 ft-lbs.
40 - 46 Nm.
Impeller to be positioned
against bearing before
tightening set screw.
Marked side of worm
gear must contact against
left thrust washer to assure
proper gear mesh.
Auger assembly
stamped "R".
Auger assembly
stamped "L".
Torque to
18-21 ft-lbs.
24 - 28 Nm.
Apply grease until
it appears at ends
of auger assembly
(2 places).
Torque to 9 - 11 ft-lbs.
12- 15 Nm.
38" Models only.
1
2
3
4
5
6
7
8
9
10
12
13
14
15
16
17
18
19
20
21
22
30
24
25
28
27
2
10
10
6
26
14
18
11
29
29
33
32
31
34
36
35
15
23
985466R1
The above parts group applies to the following Mfg. Nos.:
2005
22
© Copyright Simplicity Manufacturing, Inc. All Rights Reserved.
1694847 - 10560E
1694848 - 10560EX
1694849 - 11570E
1694850 - E11570
1694851 - 1380E
1694852 - E1380
1694867 - 9560E
1694872 - 1390E
1694914 - 9560EX
1694915 - 1390EX
TP 400-4250-00-LW-S
