© 2017 Johnson Controls. All rights reserved. All specifications and other information shown were current as of document revision and are
subject to change without notice. Additional listings may be applicable, contact your local Simplex® product supplier for the latest status.
Listings and approvals under Simplex Time Recorder Co. SIMPLEX, and the product names listed in this material are marks and/or registered
marks. Unauthorized use is strictly prohibited. NFPA 72 and National Fire Alarm Code are registered trademarks of the National Fire
Protection Association (NFPA).
579-1203
Rev. B
*05791203B*
R
IMPORTANT.
When the notification appliance emits light or sound, it indicates the possibility of an emergency situation that requires immediate attention
of all occupants.
LOCATION REFERENCE.
Location and quantity of Appliances required must conform to the applicable local standards and guidelines (the National Fire
Alarm and Signaling Code (NFPA 72); ULC Standard CAN/ULC-S524, Installation of Fire Alarm Systems; the appropriate model building codes, and so on)
and specific requirements of the Local Authority Having Jurisdiction (AHJ). These Notification Appliances are not intended for installation within hazardous
locations as defined by the National Electrical Code (NEC) or NFPA.
SAFETY.
Always install, maintain, and test notification appliances within their specifications. Failure to follow all safety precautions and instructions may
result in loss of life and property due to non-functioning notification appliances. Some notification appliances use high voltage. To avoid electrical hazards
and avoid damage to appliances, make sure that the electrical power for the notification appliance circuit is disconnected at the control panel before
installing, repairing, or internally adjusting any notification appliances. Even with electrical power removed, some notification appliances (such as visible
strobes) store a high voltage charge. The high voltage can cause injury resulting in death from electrical shock. DO NOT TOUCH EXPOSED CIRCUITRY.
UL listed TrueAlert ES indoor product identification reference
Mounting instructions
1. Select the desired location and install the electrical box using screws suitable for the mounting surface.
2. Connect the building wires to the terminal block on the rear of the appliance. See
3. Secure the appliance to the electrical box by using the provided hardware.
4. Set the appliance settings. See
Setting the address DIP switch on page 3.
5. Attach the cover to the appliance.
Type
Cover colors
Models
Operation
Ceiling Mount
Speaker/Visible
(S/V)
Red
White
Black
Components:
49SV-APPLC
49HFV-APPLC
49SV-APPLC-BA
49HFV-APPLC-BA
49SVH-APPLC-BA
49HFVH-APPLC-BA
49SVH-APPLC
49HFVH-APPLC
Covers:
49SVC-CK
49SVC-CRALT
49SVC-CRFIRE
49SVC-CRS
49SVC-CRBC
49SVC-CWBC
49SVC-CWFIRE
49SVC-CRFEU
49SVC-CRBF
49SVC-CWALT
49SVC-CWBA
49SVC-CRBA
49SVC-CWS
49SVC-CWBF
49SVC-CWFEU
These appliances provide an audio (SO) or
audible/visible (S/V) warning of an alarm
condition when activated from the control
panel of a compatible UL/ULC Listed,
Simplex Fire Alarm System. Consult Simplex
Fire Alarm panel documentation for
compatibility information.
Speakers may be turned ON/OFF
individually under control of a compatible
panel.
S/V models ‘49HFV’ have Hi intensity
strobes; models ‘49SV’ have standard range
strobes.
Ceiling Mount
Speaker Only
(SO)
Red
White
Black
Components:
49SO-APPLC
49HF-APPLC
49SO-APPLC-BA
49HF-APPLC-BA
Covers:
49SOC-CK
49SOC-CW
49SOC-CR
49SOC-CWALT
49SOC-CRALT
49SOC-CRFIRE
49SOC-CRS
49SOC-CWFIRE
49SOC-CWS
Note:
For information on appliance testing consult
TrueAlert ES Addressable Appliances Troubleshooting
Guide
(579-1049).
Kit contents:
Appliance (x1): with 8-32 1 in mounting screws (x2).
Tightening torque: 12-15 in/lbs, do not over tighten.
Not included:
Order a cover separately for each appliance.
Electrical box: 4 in square, 2-1/8 in minimum depth required.
Figure 1. Mounting instructions
Cover
S/V Appliance
4 in. x 4 in. Electrical Box (2-1/8 in. deep)
Screws -Use 8-32 screws for a 4 in. x 4 in. electrical box
Cover
SO Appliance
4 in. x 4 in. Electrical Box (2-1/8 in. deep)
-Use 8-32 screws for a 4 in. x 4 in. electrical box
Screws
Document:
Installation Instructions
Product:
TrueAlert ES Addressable
Ceiling Mount Speaker Indoor
Notification Appliances
