Mounting the BNIC
The BNIC must be mounted in the master controller cabinet and can be placed in any open expansion bay slot.
Use the following steps as well as Figure 6 to properly install the BNIC:
Note:
The card must be installed with the ports facing up.
1.
Insert the Power Distribution Interface (PDI) connector on the back of the card into one of the bottom PDI connectors on the expansion bay.
2.
Secure the card in place using the provided hardware.
Figure 6: Mounting the BNIC into the expansion bay (4100ES shown)
page 7
579-949 Rev. D
4100-6047 and 4010-9914 Building Network Interface Card Installation and Programming Manual
