Simple Installation Guide
Page 3
To attach to a cellphone.
Attach the optional cellphone cable to the
connector on the left. Connect the other
end of the cellphone cable to your
cellphone. Refer to the Quick Installation
Guide that came with the cellphone cable
for instructions on how to install the
cellphone driver.
!
If both cellphone and phone
lines are attached, the 33.6
Communicator with SimpleJack will
use the cellphone and ignore the phone
line.
4 Install and start the communications
software.
Refer to the installation sheet that came
with the communications software for
instructions on how to install and start the
communications software. Use the
communications software to send and
receive data and fax.
To use the voice capabilities of the 33.6
Communicator with SimpleJack, your
computer must have a microphone and
speakers or you must use the optional line
access cable with a compatible handset.
Refer to the User Guide for information on
the optional line access cable. Be sure to
configure the communications software
for the appropriate microphone and
speakers.
5 You can remove the 33.6 Communicator
with SimpleJack when done.
Make sure the computer is not accessing
the 33.6 Communicator with SimpleJack,
then remove the 33.6 Communicator with
SimpleJack as follows:
A. Push the eject button on the computer
(if applicable).
B. Pull the 33.6 Communicator with
SimpleJack from the socket.
Installation with Windows 3.x
For installations with Windows NT,
Windows 95, OS/2 Warp or MacOS, refer
to the other pages.
1 Check for Card and Socket Services
Release 2.1 or Higher.
A. While booting your computer, press
<F8>. With MS-DOS 6 or higher, this will
load the drivers in CONFIG.SYS one line
at a time.
B. When prompted, press “Y” to load
each driver and look for messages
indicating that Socket Services Release 2.1
(or higher) and Card Services Release 2.1
(or higher) are loading.
C. If you require Card and Socket
Services, contact your computer
manufacturer for a copy and install
Card and Socket Services before
continuing.
D. If you have Card and Socket Services
installed, let the computer boot to the DOS
prompt. Start Windows 3.x.
2 Plug in the 33.6 Communicator with
SimpleJack.
The computer may respond with a tone
when the computer recognizes the 33.6
Communicator with SimpleJack.
3 Attach the cables.
To attach to a phone line.
Lift the hinged top of the SimpleJack
connector and attach a phone line. If there
is no room to open the jack, slide the jack
out and attach the jack to the connector on
the right; then, attach the phone line.
If you find that the SimpleJack connector
is not appropriate for your application,
you may purchase a line access cable (P/N
STI-FAX/CCBL). Call 1-800-4SIMPLE for
ordering information. Refer to the User
Guide for instructions on how to install
the optional line access cable.
