• Keep sensor window clean.
• Not intended to be used in wet
environments.
• Do not submerge in water.
• Use only indoors.
• Mantener el sensor limpio.
• No usar en ambientes húmedos.
• No sumergir en el agua.
• Usar sólo en interiores.
• Conservez la zone du capteur propre.
• N’est pas conçu pour être utilisé
dans des environnements humides.
• Ne pas immerger dans l’eau.
• Utiliser uniquement à l’intérieur.
• Halten Sie den Sensor sauber.
• Nicht zur Nutzung in nasser
Umgebung geeignet.
• Nicht wasserdicht.
• Nur zur Innennutzung geeignet.
• センサーの部分を清潔に保って下さい。
• 高温多湿の場所では使用しないで下さい。
• 水の中に入れないで下さい。
• 室内でのみ使用して下さい。
use & care
/ usos y cuidados / utilisation et entretien / Benutzung und Pflege /
使用と注意
FCC statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
Indoor use only
The distance between user and products should be no
less than 20cm
IC statement
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference
that may cause
undesired operation of the device.
The distance between user and products should be no less than
20cm .Indoor use only.
Cet appareil contient des émetteurs / récepteurs exemptés de
licence conformes aux RSS (RSS) d'Innovation, Sciences et
Développement économique Canada. Le fonctionnement est
soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris
celles susceptibles de provoquer un fonctionnement indésirable de
l'appareil.
La distance entre l'utilisateur et de produits ne devrait pas être
inférieure à 20cm
Input: 16.5V, 2A
model no. ST3044
