Simpled HF-SP, Руководство пользователя

Страница: 10 / 22

Step 4 Install Back Panel
Installation
Step 5 Install Back Panel
Step 6 Install the Battery
Front Panel:
1. Locate the lock body on thespindle,
thread the cable through the hole.
Make sure the split pin does not touch
the door frame.
Tip: Use masking tape to hold the front handle in place.
Inner Handle:
1. Fit the rubber gasket to the inner panel.
(Use some masking tape to hold in place)
2. Use a screwdriver to remove the battery cover from the back handle.
(You may need to use the clear suction cup to grip the battery cover.)
3. Connect the cable and then carefully push any excess cable
back into the hole cavity.
4. Align the lock body over the spindle.
5. Make sure that the spindle connects fully.
Tighten the back panel screws.
1. (Alkaline Batteries are highly recommended)
2. Fit the battery cover and secure it with the screw.
Lift the handle up to engage the deadbolts/hooks and then pull
the handle down to disengage.
The internal handle should always open the door.
TEST: Try pulling the outer handle down. It should move but do nothing.
Then insert the keys and turn. Try lifting the handle and then pull down.
This time the latch/hooks should retract.
Nice Job. You have successfully installed the Simpled Smart Door Lock.
You can now peel the protective film from the keypad.
Please keep the backup keys in a safe place outside the home.
Tips
.: 7 :.
Overview Installation Operation FAQ Contact Us