No changes may be made to the core
protection adapter.
3 Installation Z4.KA &
Z4.KA.SET
1. Dismount outside knob with the aid of the
installation tool.
2. Remove 0-ring on the core tube with a suitable
tool.
9
NOTE: The cylinder may not deform!
3. Apply adapter and turn while holding on to the
knob until it can be full pushed onto the core
tube.
9
The cross hole of the adapter is flush with
the cross hole of the core tube.
4. Insert the enclosed pin with the thinner side at
the front of the side through the adapter hole
on which the thread is to be seen.
5. Fasten the pin with a suitable screwdriver.
9
NOTE: The thread may not be destroyed.
6. Make sure that the pin does not protrude on any
side of the adapter.
7. Mount the outside knob with the aid of the
installation tool.
4 Installation Z4.MP.KA.SET
Freely rotating, digital locking cylinders only
(except AP2.FD).
1. Use the installation tool to remove the outer
thumb-turn.
Z4 (.MP) .KA (.SET)
3. Installation Z4.KA &
Z4.KA.SET
8 / 32
EN
