Simons Voss Technologies SmartRelay SREL Series, Руководство пользователя

Страница: 13 / 38

4 Initial operation
Check
1. Unpack SmartRelay and check for any damage.
2. Connect SmartRelay to a power supply or a battery.
3. Activate the SmartRelay with a transponder and test whether the
SmartRelay responds to activation in some way or other.
Programming
Programme the SmartRelay with the appropriate software, e.g. LSM
Software for SmartRelay 3063. The SmartRelay must be connected to a
power source for the programming process. You will find the details on
programming in the LSM Software here:
Configurations in the software
[
}
24]
Connection and installation
ü
The SmartRelay is not connected to any power source and is in a de-
energised state.
1. Use backup battery: The positive terminal on the 3V-CR1220 battery
faces upwards in all SmartRelays.
2. Connect all cables to their designated terminals on the SmartRelay
(see
Connections [
}
14]
)
3. Switch on the power supply (connect the plug or battery if required).
4. Use an authorised transponder to test the programmed SmartRelay.
5. Install SmartRelay.
9 Remove the housing if you install in a flush-fitted masonry box.
SmartRelay circuit boards come in two different sizes. Check that
the SmartRelay circuit board fits into your flush-fitted masonry box
before installing SmartRelay.
9
If mounted on the surface, the base plate can be used as a template
for the drill holes (6 mm).
IMPORTANT
The backup battery must not be used if SmartRelay is powered by a bat-
tery (SREL.BAT).
SREL1+2 (Manual)
4. Initial operation
13 / 38