Simons Voss Technologies SmartRelay SREL Series, Руководство пользователя

Страница: 24 / 38

6 Configurations in the software
SmartRelays are very specific due to their hardware and can therefore only
be operated in environments designated for them.
Item order code Protocol generation Software
SREL
G1: Type G1 or G2 + G1
locking systems only
LSM
SREL.ZK
SREL.ADV
SREL.G2
G2: Type G2 locking sys-
tems only
SREL.ZK.G2
SREL.G2.W
SREL.ZK.G2.W
SREL2.G2.W
SREL2.ZK.G2.W
SREL2.ZK.MH.G2.W
MK.SREL2.ZK.G2.W
MobileKey MobileKey
MK.SREL2.LN.ZK.G2.W
6.1 LSM
The SmartRelay's settings can be adjusted in the "Configuration/Data" tab
in the locking device's properties.
6.1.1 Locking device properties: Configuration/Data: SmartRelay (G1)
This tab is divided into two sides:

The left side shows the target status of the locking device – i.e. the
desired status configured in the LSM software.

The right side shows the locking device's current status – i.e. the status
which was last programmed.
The following features can be enabled depending on the locking device
type :

Access control
Only possible in SREL.ZK and SREL.ADV versions. The 1,024 most
recent transponder transactions are logged with the date and time.

Time zone control
Only possible in SREL.ZK and SREL.ADV versions. A time zone plan can
be uploaded and the transponders are approved or blocked according
to their time zone group.

Overlay
SREL1+2 (Manual)
6. Configurations in the software
24 / 38