Simoniz 039-8578-4, Инструкция по использованию и уходу

Страница: 20 / 25

Maximum Pressure 3200 PSI
Rated Water Pressure 2500 PSI
Maximum Water Flow
10 litres per minute
LPM (2.6 gallons
per minute GPM)
Minimum Inlet Pressure 30 PSI
Maximum Inlet Pressure 100 PSI
Pump Type
Heavy-duty main-
tenance free axial
cam
Thermal Relief Valve Included
Detergent Tank (Vo-
lume)
0.75 L each (0.2
Gal)
Maximum Temperature
of Pumped Water
40
℃
(104
℃
)
Engine Power (OHV) 6.5 HP
No Load Speed 3600 RPM
High Pressure Hose
Length
15 m (50')
Inlet & Discharge Ports
13 mm (3/4")
standard garden
hose connector
Displacement 196 (cc)
Net Weight 38 kg (83.8 lbs)
Oil Type SAE 10W30
Oil Capacity 0.6 L
Fuel Type Unleaded Gasoline
Fuel Tank 3.8 L
Cleaning and Maintenance/Technical Specifications
20
7. C
LEANING AND
M
AINTENANCE
• Make sure the engine
I/O switch (12) is set to
O position. Slowly pull the starter cord handle
(7) until you feel tension, which indicates the
piston is on its compression stroke and leave it
in this position.
• Replace the spark plug.
7.5 Winterizing Procedures
• Pressure washer might be damaged if sub-
jected to freezing temperatures. This type of
damage is not covered by the limited warranty.
To avoid possible damages, use a small
amount of antifreeze.
• Place the pressure washer on its side, with
the water inlet (17) facing upwards, and pour
1/4 cup of antifreeze into the water inlet (17).
• Make sure the engine
I/O switch (12) is set to
O position and pull the starter cord handle (7)
several times to distribute the antifreeze inside
the pump system.
• When taking the pressure washer out of sto-
rage, run water through the system until it runs
clear.
IMPORTANT
• If the pressure washer is to be stored with gasoline
in the fuel tank and carburetor, it is important to re-
duce the hazard of gasoline vapor ignition.
• Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a
furnace, water heater, or clothes dryer. Also avoid
any area with a spark-producing electric motor, or
where power tools are operated.
• If possible, avoid storage areas with high humidity,
because that promotes rust and corrosion.
• Place the pressure washer on a level surface. Tilting
can cause fuel or oil leakage.
• Do not use plastic sheets as a dust cover. A non-
porous cover will trap moisture around the pressure
washer, promoting rust and corrosion.
8. T
ECHNICAL
S
PECIFICATIONS