Operation Instructions
Operation Instructions
17
17
6. O
PERATION
I
NSTRUCTIONS
6. O
PERATION
I
NSTRUCTIONS
6.1 Using Spray Nozzle
6.1 Using Spray Nozzle
This pressure washer comes with 5 different
nozzles (1) that can be installed on the stain-
less steel wand (11).
The spray pattern is adjusted by installing the
appropriate spray nozzle (1).
This pressure washer comes with 5 different
nozzles (1) that can be installed on the stain-
less steel wand (11).
The spray pattern is adjusted by installing the
appropriate spray nozzle (1).
0
°
(red):
thin and powerful stream of water for
difficult stains and debris removal
15
°
(yellow):
thin-angled spray for detailed
cleaning
25
°
(green):
medium-angled spray for detailed
cleaning
40
°
(white):
large pattern for wider cleaning
applications
Detergent (black):
this nozzle must be used
together with a cleaning detergent at a low
pressure. Use only this nozzle when using a
detergent.
Installing spray nozzle to the quick-connect
coupler:
0
°
(red):
thin and powerful stream of water for
difficult stains and debris removal
15
°
(yellow):
thin-angled spray for detailed
cleaning
25
°
(green):
medium-angled spray for detailed
cleaning
40
°
(white):
large pattern for wider cleaning
applications
Detergent (black):
this nozzle must be used
together with a cleaning detergent at a low
pressure. Use only this nozzle when using a
detergent.
Installing spray nozzle to the quick-connect
coupler:
Pull the coupler ring back and insert the desired noz-
zle (1).
Release the coupler ring to lock it back in place.
Pull the coupler ring back and insert the desired noz-
zle (1).
Release the coupler ring to lock it back in place.
13
13
6.2 Water Supply (Cold Water Only)
6.2 Water Supply (Cold Water Only)
•
The unit must be used with cold water supply
only. The water hose must be at least 13 mm
(1/2
”) in diameter.
•
The water flow rate must not fall below 18
litres per minute LPM (4 gallons per minute
GPM), or the pump might be damaged. The
flow rate can be determined by running water
for one minute into an empty container.
•
The water supply temperature must not ex-
ceed 40
℃
(104
℉
).
•
The unit must be used with cold water supply
only. The water hose must be at least 13 mm
(1/2
”) in diameter.
6.3 Adjusting Water Pressure
6.3 Adjusting Water Pressure
The water pressure can be adjusted using the
throttle lever (6).
•
Move the throttle lever (6) to
FAST
position
to increase the engine speed, thus increasing
the water pressure. Move it towards
SLOW
position to decrease the engine speed, thus
decreasing the water pressure.
The water pressure can be adjusted using the
throttle lever (6).
•
Move the throttle lever (6) to
FAST
position
to increase the engine speed, thus increasing
the water pressure. Move it towards
SLOW
position to decrease the engine speed, thus
decreasing the water pressure.
6.4 Using Pressure Washer
6.4 Using Pressure Washer
•
Start the engine (
→
Starting Engine).
•
Install appropriate spray nozzle (1).
•
Release the trigger safety lock (2) if it is
locked.
•
Purge the air by squeezing the trigger on the
gun until there is a steady stream of water.
•
Position the tip of the wand (3) 15-20 cm
(6-8
”) away from the surface to be cleaned, at
an angle appropriate to the spray nozzle used
(0
°
, 15
°
, 25
°
or 40
°
).
•
Start the engine (
→
Starting Engine).
•
Install appropriate spray nozzle (1).
•
Release the trigger safety lock (2) if it is
locked.
•
Purge the air by squeezing the trigger on the
gun until there is a steady stream of water.
•
Position the tip of the wand (3) 15-20 cm
(6-8
”) away from the surface to be cleaned, at
an angle appropriate to the spray nozzle used
(0
°
, 15
°
, 25
°
or 40
°
).
WARNING
–
NJECTION HAZARD
• Pressure washer can cause serious injury if the
spray penetrates the skin. Do not point the gun at
anyone or any part of the body. In case of penetra-
tion, seek medical aid immediately.
WARNING
–
NJECTION HAZARD
• Pressure washer can cause serious injury if the
spray penetrates the skin. Do not point the gun at
anyone or any part of the body. In case of penetra-
tion, seek medical aid immediately.
WARNING
–
DEPRESSURIZED
••
After cleaning is completed turn off the water
supply and pull the trigger to depressurize the unit.
Failure to do so might result in personal injury due
to discharge of high-pressure water.
WARNING
–
DEPRESSURIZED
••
After cleaning is completed turn off the water
supply and pull the trigger to depressurize the unit.
