11
12
ASSEMBLY AND OPERATING INSTRUCTIONS
Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure
water to penetrate and remove the dirt more effectively. Always spray detergent on a dry
surface, do not pre-soak area. Wetting the surface first dilutes the detergent and reduces
its cleaning ability.
To apply detergents you must be operating at low pressure. This provides a gentle
application of detergent, with the pressure equivalent to that of a garden hose.
The high-pressure setting is used for cleaning; you cannot apply detergents when working
at high pressure. Always test detergent in an inconspicuous area before use.
CAUTION
Only use cleaning detergents recommended for pressure washers.
WORKING WITH DETERGENTS
1
Engage gun safety lock.
Attach the low-pressure spray tip (black) for
soap application.
3
2
Turn on the pressure washer. Pull the trigger to operate the unit. The liquid detergent will
automatically mix with water, and be discharged through the nozzle. Apply detergent to a
DRY work surface, from bottom to top.
Gently pull the detergent containers out of storage position, and fill with detergent.
Push the containers back into storage position.
SHUTTING DOWN AND CLEANING UP
1
3
2
4
(If you are not using detergent, go directly to Step 2.) When you have finished using
the detergent injection system, the detergent bottle with clean water. Siphon water
at low pressure for one minute so that all the detergent is flushed through the system.
Remove the detergent bottle and rinse it until it is thoroughly cleaned.
Unplug the power cord from the outlet.
Turn the switch to “OFF” (0) position.
Press the trigger to release any remaining water pressure.
5
6
Disconnect the garden hose from the water inlet on the unit.
WARNING
Turn off water supply and squeeze trigger to depressurize the unit. Failure to do so
could result in personal injury due to discharge of high-pressure water.
TAKING A BREAK
1
3
2
Engage the gun safety lock.
Engage the gun safety lock.
Unplug the power cord from the outlet.
Turn the unit to “OFF” (O) position.
If taking a break of five minutes or more:
ASSEMBLY AND OPERATING INSTRUCTIONS
4
5
6
Allow detergent to remain on the surface for a short time before rinsing. Do not allow
detergent to dry on surface.
Rinse with clean water under high pressure. On a vertical surface, rinse from the
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8” (15-20
cm) from the work surface, at a 45° angle.
When you have
using the detergent injection system, detergent bottle
with clean water. Siphon water at low pressure for one minute, so that all detergent
is flushed through the system. Remove detergent bottle, and rinse it until it is
thoroughly cleaned.
CAUTION
Damage may occur to painted surface if chemical is allowed to dry on surface. Wash
and rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.
