10- ENG
A08987
HOW TO APPLY
DETERGENT/CLEANING
SOLVENTS
Applying detergent/cleaning solvents
is a low pressure operation.
NOTE:
Use only detergent/cleaning solvents
designed for pressure washer use.
Do
not use bleach.
To Apply detergent/cleaning
solvents:
1. Press detergent injection hose
onto barbed fitting located near
high pressure hose connection of
pump as shown in Fig. 8.
2. Place other end
of detergent
injection hose with filter
on it into container holding
detergent/cleaning solution.
NOTE:
For every 7 gallons
of water pumped 1 gallon of
detergent/cleaning solution will
be used.
3. Set multi-adjustable nozzle
to
low pressure setting. See How
To Use Wand paragraph in this
section.
4. After use of detergent/cleaning
solvents,
place
detergent
injection hose
into container
of clean water and draw
clean water through detergent
injection system to rinse system
thoroughly. If detergent/cleaning
solutions remain in the pump
it could be damaged. Pumps
damaged due to detergent/
cleaning solvents will not be
covered under warranty.
NOTE:
Detergent/cleaning solvents
will not siphon when spray wand is in
the high pressure setting.
Barbed Fitting
STARTING
Prior to starting, refer to your Engine
owner's manual for proper starting
procedures.
1. In a well-ventilated outdoor
area
add fresh, high-quality,
unleaded gasoline with a pump
octane rating of 86 or higher. Do
not overfill. Wipe up spilled fuel
before starting the engine. Refer
to Engine Owner's Manual for
correct procedure.
2. Check engine oil level.
See
Engine Owner's Manual for
correct procedure.
NOTE: There
will be a slight amount of oil in
the engine from factory testing.
3. Verify the filter screen
is in water
inlet of pump (see Fig. 9).
NOTE:
Cone side faces out.
4. Connect
water supply to pump
inlet (see Fig. 10).
NOTE:
Water
supply must provide a minimum of
5 gallons per minute at 20 PSI.
5. Connect
high pressure hose to
pump outlet (see Fig. 10).
6. If applying a detergent or
cleaning solvents
, see How
To Apply Detergent/Cleaning
Solvents instructions in this
section.
7. Turn water supply on.
NOTE:
Failure to do so could
cause damage to the pump.
Filter Screen
High-pressure
hose hook-up
Fig. 8
Fig. 9
Water supply
Fig. 10
