ASSEMBLY
Upon receipt inspect box for all parts.
Screw on optional die.
Prior to use attach air hose to air inlet of foot switch using proper wrench size. Attach two hoses from
foot switch to back of power pack. Check that all threads are free of debris.
Attach air hose to Air filter/Regulator using a quick disconnect device. Be sure that air hose is secure.
There should be no air leaks. If there is, remove hose and check threads for damage. Reattach air
hose, tighten.
ISOLATE AIR WHILE ATTACHING DIE OR WORKING ON UNIT!
Test unit to assure free movement of jaws. Be sure to follow all safety instructions when testing.
Once unit has been tested and safety issues addressed the unit is ready for production line use.
TO REMOVE CUTTING BLADE 7A-CLP
Disconnect air supply
Unscrew part 1F (piston) from part 9 (base).
Remove part 6 (cover plate).
Hold the seal end of the piston shaft part 2 in a vise and with a thin open end wrench remove the cutter
blade from the shaft.
ASSEMBLY IN REVERSE ORDER
Simonds
CLP-274-ALUM
is a pneumatic tool intended to cut or crimp wires. Any use other than
intended by Simonds Inc. may void all warranties.
WARRANTY
Simonds Inc. power packs are warranted to be free from defects in materials and
workmanship for a period of one year, barring alterations, abuse or misuse. All products
returned for warranty repair must be sent to Simonds Inc., Southbridge, MA at end users
expense. Simonds will either repair or replace the tool if it is found defective due to
material defect or workmanship at Simonds discretion.
Warranty repairs accepted only through distributors with proper RMA’s.
