Simon XTi System Manual
http://alpha.adt.com/help/266[11/14/2018 8:05:18 PM]
Special Chime
To enable or disable the special chime feature:
1. Enter the Status & Settings menu and scroll to the Special Chime option.
2. Press [On] or [Off] to modify the setting (a gold icon indicates the option is selected).
3. Press [Close] to exit the Status & Settings menu.
Note: This menu option will not appear if special chime sensors are not in your system.
Panic Alarms
Emergency Icon
In an emergency, touch the Emergency icon. An Emergency screen appears. You will see three icons
(Panic, Police, or Fire). Select the appropriate icon.
Note: If your system is connected to a security monitoring service, the authorities willbe notified. This
option may not be enabled.
If you initiate an emergency alarm by mistake, you can cancel the alarm by touching the red alarm icon
(“Alarms” on page 12) and entering your code within 30 seconds(typical time limit, contact your dealer for
more information on your system configuration).
Sirens Options
The panel has two built-in sound sources, a piezo siren and a speaker. The piezo siren makes alarm
beeps and status beeps. Fire and intrusion alarm beeps are always played at high volume, while the
volume of status beeps (such as trouble or chime beeps, entry and exit delay beeps, or emergency alarm
beeps) is controlled by the Beep Volume in the Status and Settings screen. The speaker emits the panel’s
voice and sounds beeps when a key is pressed. The siren volume is also programmable.
The siren and built-in speaker options consist of the following:
Panel Piezo Beeps
(Status beeps sounded on the siren.) This option determines whether the panel sounds nonalarm beeps.
To program piezo beeps:
1. From the Programming screen, press [SIREN OPTIONS].
2. To turn on panel piezo beeps, press the box. To turn off, press the checked box.
3. Press [CLOSE] repeatedly to exit menus.
