Simon M-SHEV Series, Руководство по эксплуатации

Страница: 23 / 24

BA_M-SHEV_EN_17
www.simon-protec.com
Date: 30.07.2019
Issue: 1.7/07.2019
info@simon-protec.com
Page 23
Commissioning
5 Commissioning
5.1 M-SHEV-10-AP
 Place the pair of batteries on the bottom plate of the
housing.
 Connect the battery from the black “–” and red “+” battery
connection cables and the attachment cable.
 Connect the PE cable to the PE connection on the lid.
 Fit the lid and fasten it at the side using the two screws.

The lid has symmetrical fastening features, i.e. it can be
used on the “right” or “left”. The lid can alternatively be
equipped with a lock.
5.2 M-SHEV
 Place the pair of batteries on the bottom plate of the
housing.
 Connect the battery using the black “–” and red “+” bat-
tery connection cables and the attachment cable.
Figure 25: Battery connection
 Ensure that the PE connection is attached to the lid.
Figure 26: PE connection
ATTENTION
The battery may only be connected once
permanent on-site power supply or mains
supply is ensured.
If the mains supply is not permanently en-
sured during commissioning, there is a risk
of total discharge. This causes damage to
the battery.