7
Customer Service [email protected]
www.DeltaChildren.com
M6 (3.5cm) (X2)
*Screw is actual size to scale
FRO
NT
FRO
NT
FRO
NT
FRO
NT
Attaching Power Housing to Top Frame Assembly
Attaching Casters To Front & Rear Base Legs
1
1
ATTACHING POWER HOUSING TO TOP FRAME ASSEMBLY
• Flip over the top frame assembly and locate the power housing, two (x2) M4 x 2.5cm screws and a Phillips screwdriver.
• Align the power housing holes to the mattress board cross tube holes. Next using a Phillips screwdriver, tighten two (x2) M6 screws to the power
housing until it is fully attached to the mattress board cross tubes (Fig.1 ).
NOTE: Pull outward on the auto-glide housing to make sure it is securely attached.
ATTACHING CASTER TO FRONT & BASE LEGS
• Locate the Front Base Leg and two (X2) casters and attach to the base leg till it locks in place (Fig.1 ).
• Repeat steps for the Rear Base Leg.
NOTE: Pull outward on the auto-glide housing to make sure it is securely attached.
Fig. 1
*Fully Assembled Base Leg
Mattress Board
Cross Tubes
Power Housing
M4 (2.5cm)
(X2)
*Screw is actual size to scale
Fig. 1
