Simex PUR-94, Руководство пользователя

Страница: 60 / 76

User manual - CONTROLLER PUR-94
11. THE MODBUS PRO TOCOL HANDLING
Transmission parameters: 1 start bit, 8 data bits, 1 or 2 stop bit (2 bits are send, 1 and 2 bits
are accepted when receive), no parity control
Baud rate: selectable from: 1200 to 115200 bits/second
Transmission protocol: MODBUS RTU compatible
The device parameters and display value are available via RS-485 interface, as HOLDING-
type registers (numeric values are given in U2 code) of Modbus RTU protocol. The registers
(or groups of the registers) can be read by 03h function, and wrote by 06h (single registers) or
10h (group of the registers) accordingly to Modbus RTU specification. Maximum group size for
03h and 10h functions can not exceeds 16 registers (for single frame).
The device interprets the broadcast messages, but then do not sends the answers.
11.1. LIST OF REGISTERS
Register Write Range Register description
01h No -999 ÷ 9999 Measurement value (no decimal point)
02h No
0h, A0h, 60h,
C0h, 10h,
20h
The status of the measurement; 0h - data valid; A0h - top border of
the measurement range is exceeded; 60h - bottom border of the
measurement range is exceeded; C0h - sensor failure; 10h - error
of user characteristic; 20h - waiting for the first measure
03h Yes 0 ÷ 3
“ Pnt ” parameter in “ InPt ” menu (decimal point position)
0 - “ 0 ”; 1 - “ 0.0 ”; 2 - “ 0.00 ”; 3 - “ 0.000 ”
04h Yes see descr.
State of the relays and alarm LED (binary format)
(1 - on, 0 - off):
00000000 000edcba
a
- relay R1;
b
- relay R2;
c
- relay R3;
d
- relay R2;
e
- alarm LED;
If written, only a , b , c , d bits are important (others are ignored)
these bits allows user to control the relays via RS-485 interface
05h
1
Yes 0h ÷ 1800h
State of active current output, expressed in 1/256 mA units – it
means that high byte express integer part, and low byte fractional
part of desired output current.
Yes 2CCh÷1800h
State of passive current output, expressed in 1/256 mA units – it
means that high byte express integer part, and low byte fractional
part of desired output current.
Yes 0h ÷ 1600h
State of active voltage output, expressed in 1/512 V units – it means
that high byte express integer part, and low byte fractional part of
desired output voltage.
06h No -999 ÷ 9999 Peak (drop) value (no decimal point)
08h No 0 ÷ 50 Temperature inside device housing expressed by 1°C
60
i