05
Rear Panel Connections
Figure 1: MOON 110LP v2 back panel
POWERING UP THE UNIT FOR THE FIRST TIME
Since the MOON 110LP v2 is not equipped
with an on/off power switch, when connecting/
disconnecting the AC power cord you are actually
turning the unit on/off. Prior to making the power
connection for the first time, make sure that every
cable is properly connected to avoid any problems.
Once the unit is connected to an AC source, the
blue LED on the unit’s front panel will illuminate.
1. Connect the turntable output cables to the left and right input connectors of the MOON 110LP v2.
2. Connect the turntable ground cable to the post labeled GND on the MOON 110LP v2.
3. Connect the left and right output connectors of the MOON 110LP v2 to the preamplifier/integrated
amplifier of the audio system using RCA terminated cables.
4. Connect the power supply cable to the input labeled 24VDC INPUT.
ON AND OFF SEQUENCE
To avoid any annoying noises (ie. “thumps” and
“pops”) emanate from your speakers, you should
i) Always power up your MOON 110LP v2 before
powering up your preamplifier and/or integrated
amplifier and ii) always power down your MOON
110LP v2 after powering down your preamplifier
and/or integrated amplifier.
