5. Attach the inflate end of the AC pump nozzle
to one of the air valves on the frame by push-
ing the end firmly into the inflation port.
Be sure to close the unused valve so it doesn’t
leak air while inflating the screen.
(FIG. 5)
NOTE:
THE PUMP ATTACHMENTS SHOULD NOT BE
USED WITH THIS MODEL
6. Turn the pump to the “on” position.
(On Switch is located on the face of the pump).
NOTE:
THE FRAME SHOULD NOT TAKE MORE THAN 5
MINUTES TO INFLATE. MAKE SURE THE PUMP
ISN’T IN USE FOR MORE THEN 10 MINUTES. IT
CAN OVERHEAT!
WARNINGS:
• Never attempt to disassemble or close the
openings while pump is operating.
• Never leave pump unattended while in use.
• Never allow sand, small rocks etc… to be
sucked into the inflation or deflation port
while operating.
• Do not use under wet conditions – keep away
from water
• Never look into or point the inflate port
toward your eyes while pump is operating.
• The power supply cord cannot be replaced.
If the cord is damaged, contact Sima customer
Service for a replacement pump.
• Keep away from children
• When used outdoors or near water, use a
properly grounded GFI outlet.
FIG. 5
Page 6