4
IMPORTANT SAFETY INSTRUCTIONS
sensitive to heat, as this may result in damage caused by the
hot air outlets underneath. Should this be unavoidable take
extra precaution of protecting the surfaces with a layer of
heat resistant material.
•••••
Intense Light Source! Do not stare directly into the projection
lens as possible eye damage could result. Be especially careful
that children do not stare directly into the beam.
•••••
Do not open the projector’s cover; no user serviceable parts
are inside. Refer servicing to qualified service personnel.
Opening the projector’s cover will invalidate warranty
.
•••••
Take care not to shake the projector whilst carrying it by the
handle.
•••••
Always position the projector away from direct heat sources.
•••••
Do not touch the surface of the projection lens.
•••••
The projector must be positioned on a stable, suitable platform
or be installed using a bracket for fixed ceiling or wall
installation. Do not rest the projector on the side panels or on
the rear panel when in operation.
•••••
Take care to position cables safely, especially in dark places,
in order to avoid a trip hazard.
•••••
For installations using a ceiling or wall-mounted bracket,
carefully follow the installation and safety instructions provided
with the bracket’s literature.
•••••
Please remove batteries from the remote control if not in use
for a long period of time.
•••••
A special EVC socket on the projector’s rear panel will allow
connection to the optional Remote Input Interface (a special
cable is required).
This is not to be confused with a VESA “Plug & Display”
Never connect a computer to this socket, as the projector
and the computer may be damaged.
Please follow carefully the warnings listed below, to ensure safe
and long term performance of your projector.
•••••
Connect the projector to a power supply with a nominal voltage
within the following values: 100-240 Vac, 50/60 Hz, earthed
(Fig. 1)
.
100-240 Vac
50/60 Hz
Fig. 1
•••••
The mains plug is the disconnect device. Take care, when
installing, that the mains plug and socket outlet are easily
accessible. Never pull on the cable to take it out of the socket.
If the system is unlikely to be used for a number of days,
disconnect the power cable and other apparatus connected
to it.
•••••
To save energy, switch off the projector by using the power
switch at the rear; when in stand-by (red light on) the projector
continues to draw a minimal amount of power.
•••••
Only replace the safety fuse (on the power socket at the rear
of projector) with a fuse identical in type and characteristics
(T 3.15A H)
(Fig. 2)
.
250 V
T 3.15A H
1
2
3
4
Fig. 2
•••••
Do not switch on your projector when flammable liquids or
fumes are present. Do not pour or drop fluids in the vents.
•••••
Do not use the projector when the room temperature is above
35°C (95°F).
•••••
Do not obstruct the cooling air inlets on the top cover, or the
air outlets underneath the projector.
•••••
Do not switch on the projector if it is standing on soft surfaces
such as cushions, pillows, blankets, mattresses and carpets:
the air cooling outlets underneath could become obstructed.
•••••
Do not switch-on the projector if it is standing on surfaces