Refer to silverwingtents.com for more videos and installation instructions
NOTE: Many rack systems have a tight clearance between the roof and the rack, or are not strong enough.
This may make installation difficult. You may purchase an aftermarket rack system that will make installation
easier if necessary.
CAUTION:
You will need at least
2 people to install the SWT90 safely
. You will not be able to lift it with one
person
1. Unpack tent with care to avoid scratching the surface
of the shell.
2. Take 4 brackets and the 8 bolts. In each plate, place
one bolt into a hole on each end (Fig. 1).
3. Insert two brackets (with bolts still attached) into one
end of each channel, located at the bottom of the tent
shell. Slide them so they approximately match your
rack spacing. You will want one bracket near each cor-
ner of the tent
4. Lift tent onto the top of your rack system.
Lifting the
tent will require two people.
5. If brackets are not aligned properly with the front or
back racks, adjust them accordingly. One bolt must be
on one side of the rack, and the other bolt on the other
side for each bracket.
6. Insert the remaining 4 brackets onto the bolts and loosely attach with a nut on each bolt (Fig. 2). This bot-
tom bracket will go underneath the rack.
7. Adjust the tent (if needed) so it is square and centered on your vehicle, and adjust to remove interference
with any doors.
8. Tighten nuts until tent is snug and cannot slide.
Fig. 2
Each set of two brackets
should look like this be-
neath your vehicle rack.
Remember, the bolts
should be on either side of
the rack.
Installation Instructions
Fig. 1
The brackets, bolts, and
nuts.
Place the bolts on both
ends of the bracket. Which
hole you place the bolts in
will depend on the width
of your vehicle rack.
