![background image](http://html1.mh-extra.com/html/silverline/976889/976889_manual_1273218004.webp)
GB
Original Instructions
silverlinetools.com
4
Description of Symbols
The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use.
Technical Abbreviations Key
V
Volts
~
, a.c.
Alternating current
A, mA
Ampere, milli-Amp
Ah
Amp hours (battery capacity)
Hz
Hertz
⎓
ǡǤ Ǥ
Direct current
W, kW
Watt, kilowatt
Specification
Input power:
230V
~
50Hz, 1.2A
Output power:
22V
⎓
, 2.4A
Charging time:
1 Hour (2Ah), 2 Hours (4Ah)
Cord length:
1.8m
Protection class:
Ingress protection:
IPX0
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
General Safety
Carefully read and understand this manual and any label attached to the
tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted with
this manual. Even when used as prescribed it is not possible to eliminate all
residual risk factors. Use with caution. If you are at all unsure of the correct
and safe manner in which to use this tool, do not attempt to use it.
Battery and Charger Safety
Use the Battery Charger correctly
•
Refer to the section of this manual relating to use of the
Battery Charger (1) before attempting to charge the Battery
•
Do not attempt to use the Battery Charger with any
batteries other than those supplied.
•
Keep your Battery Charger clean; foreign objects or dirt may
cause a short or block air vents. Failure to follow these
instructions may cause overheating or fire
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard
•
Examine the Battery Charger regularly for damage,
especially the cord, plug and enclosure. If the Battery
Charger is damaged, it must not be used until it has been
repaired
•
Children should be supervised to ensure that they do not
play with the appliance
WARNING
: Do not attempt to recharge non-rechargeable batteries.
Battery & charger safety features
The Battery and Charger are fitted with a number of safety features which
may be triggered during charging or operation:
•
Over-charge protection: Charger automatically switches off
when the Battery has reached full charge capacity,
protecting the internal components of the battery
•
Over-discharge protection: Prevents the Battery from
discharging beyond the recommended lowest safety
voltage
•
Over-heat protection: Sensor switches off if the Battery
becomes too hot during operation. This can happen if the
tool is overloaded or being used for extended periods of
time. Up to 30 minutes cooling time may be required
depending on the ambient temperature
•
Overload protection: Battery temporarily stops if it is
overloaded or the maximum current draw is exceeded,
protecting the internal components. The Battery will
resume normal operation when the current draw returns to
a normal safe level. This may take a few seconds
•
Short circuit protection: The Battery will stop working
immediately if a short circuit occurs; this prevents damage
to the Battery or tool
Product Familiarisation
1.
Battery Charger
2.
Red LED
3.
Green LED
4.
Charger Terminals
Intended Use
Intelligent electronic high current battery charger exclusively for charging Li-
ion batteries from the Silverline 18V range.
Содержание 976889
Страница 2: ...2 1 2 3 4 ...
Страница 18: ...18 Notes ...
Страница 19: ...silverlinetools com 19 Notes ...
Страница 20: ...silverlinetools com ...