8
GB
Problem
Possible cause
Solution
Tool does not start when On/Off
Switch (4) is operated
No power
Check power supply
Defective On/Off Switch or tool fault
Return the tool to an authorised Silverline service centre for repair
Blade (1) not cutting correctly
Speed setting too low
Increase speed
Material may not be suitable for the blade installed
Change blade
Material not suitable for tool
For some materials, including hardened metals, compatible blades are unavailable.
Revert to alternative methods of cutting
Blade may be worn
Replace blade
Hook & Loop Sanding Sheets come
loose from Hook & Loop Backing Pad
during use
Speed set too high
Reduce speed
Too much downward pressure during use
Reduce hand pressure
Hook & loop surface of backing pad worn out
Replace Hook & Loop Backing Pad
Unknown mechanical noise
Accessory not securely fitted
Check blade or other accessory is securely tightened
Tool fault
Stop using the tool and return it to an authorised Silverline service centre for repair
Burning smell or other abnormal
operation
Tool fault
Switch the tool off and disconnect from power supply immediately. Return it to an
authorised Silverline service centre for repair
Troubleshooting
955936_Z1MANPRO1.indd 8
10/11/2015 16:54