8
GB
Problem
Possible cause
Solution
Red LED (15) and Green LED (14)
do not illuminate to indicate the
Battery (6) is correctly charging
Battery not correctly connected to Battery
Charger (12)
Clean battery socket of Battery Charger and battery contacts and fully slide
on to Battery Charger so it clicks in a locked position
Battery Charger not powered
Recheck mains connection
Battery pack has low capacity
Battery not being fully charged
Do not remove Battery until a full charge is indicated
Battery pack has been charged over 100 times and
capacity has started to reduce
This is normal for battery packs. Contact your Silverline dealer to purchase a
replacement battery pack
Multi-tool does not start when
On/Off Switch (3) is operated
Battery completely discharged
Recharge Battery or replace with a fully charged Battery
Defective Battery
Replace Battery
Tool defective
Contact your Silverline dealer or authorised service centre
Blade (1) not cutting correctly
Speed setting too low
Increase speed
Material may not be suitable for the Blade installed
Change Blade
Material not suitable for tool
For some materials, including hardened metals, compatible blades are
unavailable. Revert to alternative methods of cutting
Blade may be worn
Replace Blade
Sanding sheets come loose from
sanding pad during use
Speed set too high
Reduce speed
Too much downward pressure during use
Reduce hand pressure
Hook and loop surface of sanding pad worn out
Replace sanding pad
Unknown mechanical noise
Accessory not securely fitted
Check blade or other accessory is securely tightened
Tool fault
Stop using the tool and return it to an authorised Silverline service centre
for repair
Burning smell or other abnormal
operation
Tool defective
Contact your Silverline dealer or authorised service centre
Troubleshooting
Accessories
• A full range of oscillating multi-tool accessories, including different saw blades,
scrapers, grinding and sanding accessories is available from your Silverline stockist
Maintenance
WARNING:
Before carrying out any maintenance/cleaning on the Battery Charger
(12), ALWAYS disconnect from the mains power supply.
WARNING:
Before carrying out any maintenance/cleaning on the multi-tool, ALWAYS
remove the battery.
Note
: There are no user-serviceable parts in both the oscillating multi-tool and the Battery
Charger. If the device does not perform as outlined in this manual, return it to an authorised
Silverline service centre for repair.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs
should be carried out by an authorised Silverline service centre. This advice also applies
to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the machine’s service life. Clean the body of your machine with a soft
brush, or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
• Always remove the battery before storing this tool
• If storing for an extended period of time, store the battery at full-charge, separate from
the tool, and ensure the battery is recharged every 3 months
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
900798_Z1MANPRO1.indd 8
29/06/2016 09:40