8
GB
Wheel brush
• The wheel brush is located inside the housing (Image XVI) and helps keep the blade
and the wheel free of sawdust and wood chips
• To adjust, loosen the screw and position the wheel brush so that it contacts the bristles
of the brush
• Retighten the screw
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs
should be carried out by an authorised Silverline service centre. This advice also applies
to extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the machine’s service life. Clean the body of your machine with a soft
brush, or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
Problem
Possible cause
Solution
No function when On/Off
Switch (10) is operated
No power
Check power supply
Defective On/Off Trigger Switch
Replace the On/Off Trigger Switch at an authorised Silverline service
centre
Inaccurate cut
Blade alignment off
Re-align the saw blade as specified in ‘Blade tracking’
Worn saw blade
Replace saw blade
Blade guide calibration is incorrect
Follow the instructions for blade guide calibration in ‘Adjusting the
upper blade guide stabilising bars and blade guide bracket’
Difficulty making straight cuts
Fence (20) is not parallel to the saw blade
Re-align the Fence (20) as instructed in ‘Using the fence’
Blade guide calibration is incorrect
Follow the instructions for blade guide calibration in ‘Adjusting the
upper blade guide stabilising bars and blade guide bracket’
Troubleshooting
PDF Compressor Pro
