12 GB/IE/NI
Placing the product
The product must not be placed
directly below a power supply .
Always use the product on a
flat, stable, clean, heat-resistant
and dry surface .
Operation
The product shall only be used
with the supplied base .
Do not overfill the product . If
the product is overfilled, boiling
water may be ejected . Do not
operate the product without
water . The fill level of the
product must be between the
MIN
and
MAX
marks on the
water gauge .
Cleaning and storage
The product shall not be
exposed to any dripping or
splashing water .
Disconnect the product from the
power supply before cleaning
and when not in use .
Refer to the “Cleaning and
care” section for instructions on
how to clean the product .
Before first use
Remove all the packaging materials .
Clean the product (see “Cleaning and care”) .
Boil the maximum water volume of 1 .7 litres
(see “Operation“) . After boiling, discard the
water to remove any production and transport
residues .
Operation
m
Danger of burns!
The lid
[
2]
must remain
closed when pouring hot water . Otherwise,
hot water or steam could escape over the rim
causing burns .
Placing the product
Keep the power cord
[
6]
as short as possible .
Wrap the excess power cord onto the cord
storage
[
8]
(bottom of the base
[
9]
) .
Guide the power cord
[
6]
through the power
cord guide
[
7]
.
Place the base
[
9]
on an even, stable surface .
Maintain a safe distance to walls and
cupboards to avoid damages caused by rising
steam .