Silvercrest SNMD 33 A1, Инструкции по эксплуатации и безопасности

Страница: 88 / 94

88 GB/ IE
Monogramming and embroidering with embroidery hoop*
Attach the darning plate
Preparation for Monogramming and
Embroidering*
- Remove the presser foot and the presser
foot holder.
- Attach the darning plate.
- Lower presser foot lever before starting to
sew.
- Adjust the stitch width according to the
size of lettering or design.
- Draw the desired lettering or design on
the right side of the fabric.
- Stretch the fabric between embroidery
hoop as firmly as possible.
- Place the fabric under the needle. Make
sure the presser foot bar is down in its
lowest position.
- Turn the balance wheel towards you to
bring up the lower thread through the
fabric. Sew a few securing stitches at the
starting point.
- Hold the hoop with thumb and forefingers
of both hands.
- Coordinate sewing speed and movement
of hoop.
Stitch Stitch width Stitch length
B 1~5 0
Stitch Stitch width Stitch length
B 3~5 0.5~1
Applique
* Embroidery hoop not included with machine.
- Cut out the applique design and baste it to
the fabric.
- Sew slowly around the edge of the design.
- Trim excess material outside the stitching.
Make sure not to cut any stitches.
- Remove the basting thread.
- Tie top and bottom thread under the
applique to avoid unraveling.
Sewing basics