Silvercrest SMFB 2.1 A1, Руководство по эксплуатации

Страница: 13 / 42

9 SMFB 2.1 A1
GB
IE
Preparation
Assembling the mains adapter
Assemble the mains adapter
13
, if required:
1) Push the contacts into the mains adapter
13
, as shown on the fold-out
page, until they click into place.
2) If you want to the remove the contacts from the mains adapter
13
, press
the surface labelled “PRESS” and slide the contacts upwards.
Charging the device
Before you can use the device it must be charged.
3) Connect the mains adapter
13
to the charger cable
16
.
4) Open the protective cover on the main unit and insert the micro USB plug 14
into the micro USB socket
4
on the main unit.
5) Connect the mains adapter
13
to a mains power socket. As soon as the
mains adapter
13
is connected to a mains power socket, the LED on the
mains adapter
13
lights up green. The control lamp
7
on the main unit
lights up red.
As soon as the device is charged, the red control lamp
7
goes off (after
around 2 hours). The green LED on the mains adapter
13
stays lit until the
mains adapter
13
is disconnected from the mains.
Attaching the base unit to the helmet
Install the base unit (main unit with microphone
12
and speakers
9
) in the
helmet (see Fig. 1):
1) Attach the main unit to the socket plate
11
.
2) Secure the fastening plate
10
to the rear side of the socket plate
11
with
the screws
26
(loosely to begin with).
3) The two screws
26
need to be loose enough for the base unit to be attached
to the helmet. The fastening plate
10
is on the inside and the main unit on
the outside of the helmet. The microphone
12
points forwards. Clamp the
padding and the outer shell of the helmet between the main unit and the
fastening plate
10
.
4) Then tighten the two screws
26
using the Allen key
24
. The base unit must
be attached fi rmly to the helmet!
IB_93846_SMFB2.1A1_LB6.indb 9 IB_93846_SMFB2.1A1_LB6.indb 9 02.12.13 09:11 02.12.13 09:11
145 mm x 205 mm